Tandberg Data 7000 Manuale Utente Scaricare il pdf (Pagina 43)

TANDBERG Videoconferencing System

General use

Disconnecting sites from a conference

To disconnect a site or end the conference, press DISCONNECT.

• Select site and press OK or ‘Disconnect Site’.

To end the meeting press ‘Disconnect All’.

disconnect

EACH SYSTEM WILL BE IDENTIFIED BY A

SYSTEM NAME (IF SUPPORTED) AND THE

NUMBER OF THE FAR END.

Adding an extra site - dial in

To dial in to the MultiSite on ISDN-BRI:

• Site 2 must dial MultiSite Number 2.

• Site 3 must dial MultiSite Number 3.

To dial in to the MultiSite on ISDN-PRI:

• Dial the main number of the system (‘My ISDN Number’). All sites can dial the same number.

To dial in to the MultiSite on IP:

• Dial the IP Number or the IP Address of the system (‘My IP Number’/‘My IP Address’).

When the MultiSite receives an incoming call, the following menu is displayed:

• Pressing CONNECT is equivalent to pressing ‘Accept’.

• Pressing DISCONNECT is equivalent to pressing ‘Reject’.

• Pressing ‘Do Not Disturb’ will disable the MultiSite from answering more incoming calls during the current

conference. The calling party will receive a busy signal.

TO FIND THE DIAL-IN NUMBERS FOR THE MULTISITE,

PRESS ‘MENU’ AND ‘SYSTEM INFO’

TIP

NOTE

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 117 118

Nessun commento

Tandberg Data 7000 Manuale Utente Pagina 43