Tandberg Data DPS Expansion Module Disk Pack Specifiche Scaricare il pdf (Pagina 32)

26 | Configuring DPS Expansion Module

to an IP address of 10.1.1.5 with a Subnet Mask of 255.0.0.0. If this occurs, check your

network configuration (cables, switches, and so on) to ensure they are connected correctly. If

this does not resolve the issue, set DPS Expansion Module to use a static IP address.

Setting a dynamic IP address

Because DPS Expansion Module defaults to DHCP, you do not have to switch to DHCP unless

the system defaults to an IP address of 10.1.1.5 or if you are switching from a static IP

address to a dynamic one.

To switch to a dynamic IP address

1. Access DPS Expansion Module through the serial console you connected.

2. Press Ctrl+e to open the console menu.

3. Enter 2 (Diagnostics).

4. Enter 6 (StorView Embedded Module Support).

5. Enter 2 (Enter StorView Embedded Module Menu Mode (Exit with CTRL-W)).

6. Enter 2 (Change Network Settings).

7. Enter 1 (IP Addresses).

8. Enter 1 (DHCP Setup).

9. Enter y (Dynamic IP (DHCP) enable).

10. Enter 0 (Exit) to exit this menu. Continue to enter 0 (Exit) until you reach the top level.

Setting a static IP address

If you want to set a static IP address, first determine the following information:

• The IP address you will assign to DPS Expansion Module

• The network mask associated with the IP address

• The IP address of the network gateway for DPS Expansion Module

To set a static IP address

1. Access DPS Expansion Module controller through the serial console you connected.

2. Press Ctrl+e to open the console menu.

3. Enter 2 (Diagnostics).

4. Enter 6 (StorView Embedded Module Support).

5. Enter 2 (Enter StorView Embedded Module Menu Mode (Exit with CTRL-W)).

6. Enter 2 (Change Network Settings).

7. Enter 1 (IP Addresses).

8. Enter 2 (Static IP setup).

9. Enter 1 (IP Address) and then enter the IP address.

10. Enter 2 (Network Mask) and then enter the network mask.

11. Enter 3 (Gateway Address) and then enter the gateway address.

12. Enter 0 (Exit) to exit this menu. Continue to enter 0 (Exit) until you reach the top level.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 67 68

Nessun commento

Tandberg Data DPS Expansion Module Disk Pack Specifiche Pagina 32