Tandberg Data DPS Expansion Module Disk Pack Specifiche Scaricare il pdf (Pagina 50)

44 |

7. If you need to upgrade the DPS Expansion Module interface (StorView software),

complete the following steps:

a. On the home page, click the ABOUT button in the upper right-hand corner.A dialog

box similar to the following is displayed:

b. Click UPDATE.

c. Browse to the StorView software .bin file, enter the interface password (password),

and click UPLOAD.

d. Click CLOSE to close the dialog box.

8. If one or more expansion enclosures are connected to the DPS Expansion Module

controller, you must upgrade the expansion enclosures by complete these steps:

a. On the home page, click the UPDATE EXPANSION F/W button in the lower right-

half of the page.

b. Browse to the expansion firmware. bin file and click UPLOAD FILE.

c. Click CLOSE to close the dialog box.

d. Wait three minutes to allow DPS Expansion Module to reboot.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 67 68

Nessun commento

Tandberg Data DPS Expansion Module Disk Pack Specifiche Pagina 50